Resistor color-code equation
The first bands form a significant integer and the multiplier band supplies its decimal power.
R = (10d1 + d2) × 10^mR = (100d1 + 10d2 + d3) × 10^mwhere:
- d1, d2, d3
- Significant digit colors
- m
- Multiplier-band exponent
How resistor color codes work
Digit colors encode significant figures, the multiplier band sets the power of ten, and the tolerance band defines the permitted range.
Worked color-code example
Yellow = 4, violet = 7, red = ×100, and gold = ±5%, so the nominal value is 47 × 100 = 4.7 kΩ.
Method & Sources
Method
Formula used
R = (10d1 + d2) × 10^mR = (100d1 + 10d2 + d3) × 10^m
Input basis
The first bands form a significant integer and the multiplier band supplies its decimal power.
- Calculation direction
- Number of bands
- Band 1
- Band 2
- Band 3
- Multiplier band
- Tolerance band
- Temperature coefficient band
- Resistance to encode [Ω]
- Tolerance
- Temperature coefficient
- d1, d2, d3 — Significant digit colors
- m — Multiplier-band exponent
Units
Ω
Display and rounding
No separate display or rounding rule is stated on this page.
Scope and limits
- Standard color-code convention with tolerance and optional temperature coefficient
- Confirm band order and inspect ambiguous colors under neutral lighting; photographs and poor light can change apparent colors.
Sources
- IEC 60062, resistor marking codesEdition not stated on this page; clause and table identifiers are preserved verbatim.
- IEC 60062 resistor marking codesMarking convention used for color bands and SMD codes.
Four, five, and six bands
The band count determines how many significant digits are encoded before the multiplier.
| Band count | Information |
|---|---|
| 4 | Two digits, multiplier, tolerance |
| 5 | Three digits, multiplier, tolerance |
| 6 | Five-band data plus temperature coefficient |
Reading uncertain colors
Use neutral light and compare the resistor with a known chart. If the order is uncertain, read from the separated tolerance end toward the grouped bands.
Color-code reference
The digit, multiplier, tolerance, and temperature-coefficient assignments follow the IEC 60062 resistor marking convention. Always confirm ambiguous physical markings against the component documentation.
Assumptions
- Standard color-code convention with tolerance and optional temperature coefficient
Important Warnings
- Confirm band order and inspect ambiguous colors under neutral lighting; photographs and poor light can change apparent colors.